MajesticRa

Forum Replies Created

Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 17, 2017 at 22:53 in reply to: OpenOCD st-link v2 just hangs instead of debugging #12699
    MajesticRa
    Participant

    Hi!

    1. Tried to uninstall the ST-link driver – reboot – reinstall – reboot

    2. Tried to switch to USB2.0 port, then USB3.0 port. I connect it directly to motherboard without any additional usb hubs.

    Both times it started hanging after several times going to the debug mode.

    I have a laptop with approximately the same setup but with Windows 10 pro, it works there fine
    (with the same programmer, the programmer usb cable and a controller).

    Thank you for the quick reply!
    Dmitry

    February 14, 2017 at 06:21 in reply to: Not seamless refactoring #10410
    MajesticRa
    Participant

    Thank you! That will be great!

    September 12, 2016 at 19:20 in reply to: STM32 hardware float compilation failure #9044
    MajesticRa
    Participant

    I had exactly the same issue when I first time installed VisualGDB and used my tool chain (installed somewhere in the system).  As support answers, the problem disappeared after I allowed VisualGDB to download toolchain on its own.

  • Author
    Posts
Log In Register Lost Password
Viewing 3 posts - 1 through 3 (of 3 total)