[indridkold]

Great, working now. I opened the VisualGDB project properties (which I had not found before) and the settings were incorrect. An image is attached. Once I set ‘Board part number’ to Nucleo F767ZI and the upload method to STM32CubeProgrammer everything uploaded fine and I was able to start a debug session. The board part number is not set during project creation and I didn’t realize I had to set it in Project Properties. All good now. Thanks for your help, IK

Attachments:

You must be logged in to view attached files.

[indridkold]

Thanks for the quick response. The sketch does compile and upload using Arduino, the output is attached. I’ve set the upload to use the STMCubeProgrammer(SWD). I would prefer to use that for vGDB also. An image of the Arduino settings is also attached. IK

Attachments:

You must be logged in to view attached files.

[Author]

Posts