[Coralfreak]

Hi Support,

I installed VisualGDB 6.4 preview 4 and also the latest Segger package 634a.

There is no difference with the earlier versions I have used, except that ttha Segger 634a driver gives a -1 error back and is not telling the rootcause of not being able to connect to the Segger JLINK emulator. The resetline still remains high (pin15), which is also the same as in my earlier SW setup.

I have tried to add the “mon reset 2” command in the textfield as suggested, but I do not see this being transmitted in the commandline to the JLINK emulator.

I have, as requested, attached 2 screenshots where the first is showing the parameters and the second oneif showing the commandline after the errormessage.

The JLINK is not able to connect to the MCU, as the restpulse is missing. This should be generated by the JLINK device.

Regards,

Coralfreak

Attachments:

You must be logged in to view attached files.

[Author]

Posts