Kabron

Forum Replies Created

Log In Register Lost Password
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 20, 2020 at 08:10 in reply to: Could not start with Cypress Super Speed #29312
    Kabron
    Participant

    Hello, thanks for ansver. The matter is in slightly unstable USB3 in my PC.

    Now I got it worked.

    October 20, 2020 at 03:23 in reply to: Could not start with Cypress Super Speed #29309
    Kabron
    Participant

    If I connect board in normal mode and launch SW, it ask for J4 installing and restarting.

    If I do so board become an unrecognized descriptor device.

    November 11, 2017 at 11:54 in reply to: Surprizing ESP32 support #12952
    Kabron
    Participant

    I could not find the way to display About window. What should I do?

    Now I’m trying to continue on my home PC, but trial says expired, though 8 days must left.

    • This reply was modified 7 years, 1 month ago by Kabron.
    November 10, 2017 at 16:00 in reply to: Surprizing ESP32 support #12941
    Kabron
    Participant

    Just did all symbol by symbol as described in getting started blink project.

    No output from the openocd except command line.

    November 9, 2017 at 13:53 in reply to: Surprizing ESP32 support #12920
    Kabron
    Participant

    Now I got in reply to Test and could not figure out:

    VisualGDB version: 5.3.15.1896
    —————— System.Exception ——————
    System.Exception: Stub exited before a gdb connection could be made
    at VisualGDB.Common_GUI.WPF.DebugMethodTestWindow.ThrowTestFailedException()
    at VisualGDB.Common_GUI.WPF.DebugMethodTestWindow.TestThreadBody()

    openocd launches fine from the command line.

  • Author
    Posts
Log In Register Lost Password
Viewing 5 posts - 1 through 5 (of 5 total)