How to enable the Reset line with Segger J-Link SWD?

Sysprogs forums › Forums › VisualGDB › How to enable the Reset line with Segger J-Link SWD?

Log In Register Lost Password
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 7, 2016 at 15:27 #9722
    CurtisHx
    Participant

    Is there a setting to tell a Segger J-Link to pull and release the SWD line before or after programming a target chip?  I went digging through the Debug settings under VisualGDB Project Properties without much luck.

    December 7, 2016 at 22:00 #9730
    support
    Keymaster

    Hi,

    There might be a command line switch or a “monitor” command in the Segger GDB stub for that. Please double-check that with Segger support.

  • Author
    Posts
Log In Register Lost Password
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.