Hello
I use AT91SAM7X512 board and trying to get blinking LED. I am following your tutorial on developing AT91SAM7 with Visual Studio. Everything was fine until debugging part. The debugger doesn’t stop at the breakpoint and program also doesn’t seem to be running.
Using openocd with SAM-ICE.
This is the output shows:
warn: srst pulls trst – cannot reset to halted mode. Issuing halt after reset.
sam7x512.cpu : target state: halted
target halted in ARM state due to debug-request, current mode: Supervisor
warn: NOTE:! DCC downloads have not been enabled, defaulting to slow memory writes.
warn: NOTE:! Severe performance degradation without fast memory access enabled.

• This topic was modified 8 years, 3 months ago by faris.