Automatic change between . and ->

Sysprogs forums › Forums › VisualGDB › Automatic change between . and ->

Log In Register Lost Password
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 26, 2023 at 00:39 #34743
    mattia
    Participant

    Hello,

    I’m using VisualGDB version 5.6R9 build4807. I don’t know why, but the software doesn’t change automatically from . to -> when neeeded. Where should I check this?

    Thanks,

    Mattia

    September 26, 2023 at 10:06 #34744
    support
    Keymaster

    Hi,

    We are not aware of any known problems that would cause this. A good starting point would be to try reproducing the problem on a clean project created from scratch. If you can reproduce it there, please share the repro steps that we could follow in order to reproduce the problem on our side.

    If not, please try comparing the broken project files against the working one – the difference is likely caused by some setting or something particular about the project structure.

     

  • Author
    Posts
Log In Register Lost Password
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.