OpenOCD
image::base_address is only used within OpenOCD.
 
Symbols
loading...
Files
loading...
CodeScopeDevelopment ToolsOpenOCDimage::base_address

image::base_address field

Syntax

long long base_address;

References

LocationReferrerText
image.h:54
long long base_address; /* base address, if one is set */
esp_algorithm.c:322esp_algorithm_load_func_image()
run->image.image.base_address_set ? (unsigned int)run->image.image.base_address : 0,
etm.c:1671handle_etm_image_command()
COMMAND_PARSE_NUMBER(llong, CMD_ARGV[1], etm_ctx->image->base_address);
image.c:1063image_open()
image->sections[section].base_address += image->base_address;
image.c:1067image_open()
image->base_address = 0;
lpc2900.c:628lpc2900_handle_write_custom_command()
image.base_address = 0;
target.c:3697parse_load_image_command()
image->base_address = addr;
target.c:3897handle_verify_image_command_internal()
image.base_address = addr;
target.c:3901handle_verify_image_command_internal()
image.base_address = 0x0;
tcl.c:433handle_flash_write_image_command()
COMMAND_PARSE_NUMBER(llong, CMD_ARGV[1], image.base_address);
tcl.c:436handle_flash_write_image_command()
image.base_address = 0x0;
tcl.c:485handle_flash_verify_image_command()
COMMAND_PARSE_NUMBER(llong, CMD_ARGV[1], image.base_address);
tcl.c:488handle_flash_verify_image_command()
image.base_address = 0x0;
ublast2_access_libusb.c:132load_usb_blaster_firmware()
ublast2_firmware_image.base_address = 0;
ulink.c:392ulink_load_firmware()
ulink_firmware_image.base_address = 0;
xscale.c:3427xscale_handle_trace_image_command()
COMMAND_PARSE_NUMBER(llong, CMD_ARGV[1], xscale->trace.image->base_address);

Data Use